CFMOTO
05-162
Coolant Filling
Remove the relief screw
1
on thermostat
cap.
NOTE: Both two cylinders must be vented.
Place the vehicle on flat ground and cool
down engine. Add coolant to radiator until
it comes out from the hole on thermostat
cap. Install relier screw
1
with seal washer
2
and tighten it to 5 N•m(44 lbf•in).
After full filling, install radiator cap. Add
coolant in coolant reservoir until the
level reaches lower line. Install reservoir
cap. Start and run the engine until the
thermostat opens. Then stop the engine.
When the engine cools down, inspect the
coolant level in radiator and reservoir.
Make sure the coolant level in reservoir
is between LOWER and UPPER marker
lines.
Thermostat information refers to Engine
Inspection section.
Water pump information refers to
Engine Inspection section.
Oil cooler information refers to Engine
Inspection section.
1
1
1
2
0511801
0511802
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page