CF MOTO ZForce 950EX - Page 17

02-17
02 Specications/Vehicle Data
CVT / Transmission
Item Standard - mm Limit Remark
Drive belt width 33.7(Fiber level) 32.2
Sliding sleeve diameter, driven pulley 38.10~38.14 38.30
Clearance between shifting fork and
groove
0.20~0.40 0.50
Shifting fork moving thickness 5.80~5.90 5.70
H/L sliding fork groove width 6.10~6.20 6.30
Output main gear sliding groove width 6.10~6.20 6.30
Shifting drum groove width 8.02~8.12
Shifting fork pin diameter 7.90~7.95 7.83
Shifting gear hole diameter 29.000~29.021 29.025
Reverse dual gear hole diameter 29.007~29.028 29.032
Shifting main shaft diameter
φ30 28.980~29.993 29.970
φ17 16.983~16.994 16.978
Driven shaft diameter
φ24 23.980~23.993 23.974
φ17 16.983~16.994 16.978
Drive bevel gear shaft diameter φ17 16.983~16.994 16.978
Reverse dual gear shaft diameter φ25 24.980~24.993 24.974
Ignition / EFI / Electrical
Item Standard
Ignition controller Bosch ECU
Spark plug
Type Resistance control
Model DCPR8E(NGK)
Spark clearance 0.8mm~0.9mm
Spark specication >8mm,1 kPa
Ignition coil resistance
Primary 740Ω~780mΩ
Secondary 10.1kΩ~11.1 kΩ
Peak voltage
Ignition primary ≥1.5V, 200r/min
Pulse starter ≥25kV
Start relay coil resistance 3Ω~5Ω
Start auxiliary coil resistance 90Ω~100Ω
Peak voltage of trigger coil ≥1.5V, 200r/min
Resistance of trigger coil 250Ω~300Ω
Fuses / Lights
Item Standard
Fuses
Main 40A
Secondary 5A×1 10A×2 15A×4 40A×1
Lights
Headlight
30W (High-beam) 14.2W (Low-beam)
3.5W (position light) 23W (turn light)
Brake light 4.5W
Indicators LCD+LED
Rear license light H2 W5W bulb
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.