CFMOTO
10-4
Inspection
Position the vehicle on level ground. Turn
the steering wheel slowly to inspect for
smooth movement.
Inspect main cable and wires for
interference if there is blocking or stuck
feeling. If not, inspect steering column
ends for interference and steering
universal shaft assy for damage.
NOTE: Make sure of smooth steering.
Otherwise, the steering wheel may lose
its control, which causes accidents.
Position the vehicle on level ground. Shake
the steering wheel to check its degree of
shakiness.
If shakiness is large, make sure if it is due
to looseness of steering column or other
parts. Inspect gas spring for clearance and
bolts for tightening. Operate if necessary.
If it is caused by steering column shaking,
enlarge the tighten torque of steering
column lock nuts or disassemble column
for service.
Adjust gas spring until the steering wheel
is at the appropriate position for driver.
Installation
Reverse the removal procedures for
installation.
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page