11 Cooling System
11-7
11.5 Coolant
Open radiator cap. Add coolant until there
is no bubble inside the exceeded coolant
from outlet port.
Loosen air relief bolt
1
on engine (just
several threads) until coolant overflows
from the hole on exhaust bypass. Tighten
the air relief bolt.
After full lling the coolant, install radiator
cap. Make sure the coolant lever inside the
reservoir tank is between UPPER line and
LOWER line. Install reservoir cap. Start the
engine until thermostat works. Shut down
engine.
Wait until engine cools down, check the
coolant level inside radiator and reservoir
tank. Add coolant if necessary.
If the level is below the LOWER line, add
coolant until the level reaches UPPER line.
If the level is above UPPER line, drain the
redundant coolant.
Recommended Coolant:
Coolant normal concentration of CFMOTO:
Anti-freezing agent: 50%
Water: 50%
Recommended anti-freezing agent level: 35°C
(The freezing resistance temperature of
coolant is different with different mixing
ratio.Please adjust the mixing ratio
according to the minimum temperature in
the area where the vehicle is used.)
NOTE: Never open the radiator cap
until the engine cools down to avoid
burns caused by liquid coolant.
NOTE: Do not use only antifreeze or
tap water in cooling system. Tap water
contains minerals and tends to produce
contaminants in cooling system during
usage. In cold season, pure water
can cause system damage or thicken
the coolant, which decreases cooling
efficiency. For aluminum engines, it
is strongly recommended to adhere
to ethylene glycol coolant containing
corrosion inhibitves.
1
110701
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page
Loading...
