CFMOTO
12-42
2. Fault Display
PDA monitors IAP sensor, IAT sensor,coolant temperature sensor, TPS, O2S, O2S
heater circuit, air-to-fuel ratio revision, fuel injector, fuel pump relay, CPS, speed signal,
idle speed, idle air control valve, system voltage, ECU, FI indicator and displays the fault
code.
3. Engine Data stream Display
PDA can display battery voltage, RPM, desired idle speed, vehicle speed, coolant
temperature, coolant temperature sensor signal voltage, inlet air temperature, IAT sensor
signal voltage, inlet air pressure, inlet air ow, IACV target position, TPS signal voltage,
throttle body position, throttle body relative position, canister duty, charging time, FI
pulse width, park advance angle, O2S voltage, engine relative load, canister load, IACV
position, atmospheric pressure, altitude multiplier, engine operation time.
4. EFI Status Display
Starter switch, main relay, fuel pump relay, idle speed, idle speed, full load status,
deceleration activation, acceleration activation, FI close loop activation, lambda control
activation, canister control valve activation, MIL status.
5. Actuator Test Function
MIL, fuel pump, IACV, canister control valve, ignition, fuel injection.
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page