CFMOTO
04-40
Remove cam plate
1
.
Remove shaft key
2
.
Remove driven pulley spring
3
.
Remove driven pulley stationary sheave
4
.
Inspection
Driven Pulley Sheaves
Inspect the stationary sheave surface
1
for wear, damage or other defects.
Replace if any defect is found. Inspect
shaft sleeve
2
for wear or other defects.
Replace if necessary.
NOTE: Clean before inspection.
NOTE: Driven pulley parts are precisely
matched. Replacement of separate
components may cause engine
vibration. Replace as a set.
Inspect the moveable sheave surface
1
for wear, damage or other defects.
Replace if any defect is found.
Inspect driven pulley sliders
C
for wear or
other defects. Replace if beyond value
A
.
Inspect sliding sleeve for wear or damage.
Replace if severely worn.
NOTE: Clean before inspection.
1
2
3
4
1
2
1
C
C
C
041002
041003
041004
041001
© CFMOTO Powersports, Inc. This manual is subject to all applicable copyright laws.
Reproduction or duplication in any form, whole or in part, is strictly prohbited.
To Next Page