Cisco Catalyst 3560-X - Page 1524

Index
IN-44
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
show forward command 1-22
show interfaces command 1-33, 1-39
show interfaces switchport 1-4
show l2protocol command 1-14, 1-16, 1-17
show platform forward command 1-22
show running-config command
displaying ACLs
1-34, 1-36
interface description in 1-39
shutdown command on interfaces 1-53
shutdown threshold for Layer 2 protocol packets 1-12
Simple Network Management Protocol
See SNMP
single session ID
1-35
small form-factor pluggable modules
See SFPs
small-frame arrival rate, configuring
1-5
smart logging 1-1, 1-14
SNAP 1-1
SNMP
accessing MIB variables with
1-4
agent
described
1-4
disabling 1-7
and IP SLAs 1-2
authentication level 1-10
community strings
configuring
1-8
for cluster switches 1-4
overview 1-4
configuration examples 1-17
default configuration 1-6
engine ID 1-7
groups 1-7, 1-9
host 1-7
ifIndex values 1-5
in-band management 1-8
in clusters 1-14
informs
and trap keyword
1-12
described 1-5
differences from traps 1-5
disabling 1-15
enabling 1-15
limiting access by TFTP servers 1-17
limiting system log messages to NMS 1-10
manager functions 1-6, 1-3
managing clusters with 1-17
notifications 1-5
overview 1-1, 1-4
security levels 1-3
setting CPU threshold notification 1-16
status, displaying 1-19
system contact and location 1-16
trap manager, configuring 1-14
traps
described
1-5
differences from informs 1-5
disabling 1-15
enabling 1-12
enabling MAC address notification 1-15, 1-17,
1-18
overview 1-1, 1-4
types of 1-12
users 1-7, 1-9
versions supported 1-2
SNMP and Syslog Over IPv6 1-13
SNMP traps
REP
1-13
SNMPv1 1-2
SNMPv2C 1-2
SNMPv3 1-2
snooping, IGMP 1-2
software compatibility
See stacks, switch
software images
location in flash
1-26
recovery procedures 1-2
scheduling reloads 1-24