Cisco Catalyst 3560-X - Page 1530

Index
IN-50
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
summer time 1-6
SunNet Manager 1-6
supernet 1-8
supported port-based authentication methods 1-8
SVI autostate exclude
configuring
1-42
defined 1-6
SVI link state 1-6
SVIs
and IP unicast routing
1-5
and router ACLs 1-5
connecting VLANs 1-15
defined 1-5
routing between VLANs 1-2
switch 1-2
switch clustering technology 1-1
See also clusters, switch
switch console port
1-8
Switch Database Management
See SDM
switched packets, ACLs on
1-41
Switched Port Analyzer
See SPAN
switched ports
1-3
switchport backup interface 1-4, 1-5
switchport block multicast command 1-8
switchport block unicast command 1-8
switchport command 1-30
switchport mode dot1q-tunnel command 1-7
switchport protected command 1-7
switch priority
MSTP
1-22
STP 1-22
switch software features 1-1
switch virtual interface
See SVI
SXP
1-2
synchronization, BGP 1-50
syslog
See system message logging
system capabilities TLV
1-2
system clock
configuring
daylight saving time
1-6
manually 1-4
summer time 1-6
time zones 1-5
displaying the time and date 1-5
overview 1-2
See also NTP
system description TLV
1-2
system message logging
default configuration
1-4
defining error message severity levels 1-9
disabling 1-4
displaying the configuration 1-17
enabling 1-5
facility keywords, described 1-14
level keywords, described 1-10
limiting messages 1-10
message format 1-2
overview 1-1
sequence numbers, enabling and disabling 1-8
setting the display destination device 1-5
stack changes, effects of 1-2
synchronizing log messages 1-6
syslog facility 1-18
time stamps, enabling and disabling 1-8
UNIX syslog servers
configuring the daemon
1-12
configuring the logging facility 1-13
facilities supported 1-14
system MTU
and IS-IS LSPs
1-71
system MTU and IEEE 802.1Q tunneling 1-5
system name
default configuration
1-8
default setting 1-8