Cisco ONS 15454 - Page 492

4-4
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-1044 Warning: there is a discrepancy in the build timestamp between
the NE cached jar file ({0}) and the NE ({1}).
Your CTC jar cache should be emptied.
Refer to the warning message text.
EID-1046 Selected CTC version ({0}) must be greater than or equal{to
the login NE version ({1}).
The CTC software version must be greater
than or equal to the software version on the
node being managed.
EID-2001 No rolls were selected. {0} No rolls were selected for the bridge and
roll.
EID-2002 The roll must be completed or canceled before it can be deleted. You cannot delete the roll unless it has been
completed or cancelled.
EID-2003 An error occurred while deleting the roll.
{0}
There was an error when CTC tried to delete
the roll.
EID-2004 No Cisco IOS slot was selected. You did not select a Cisco IOS slot.
EID-2005 CTC cannot find the online help files for {0}.
The files might have been moved, deleted, or not installed.
To install online help, run the setup program on the software
CD.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
EID-2006 An error occurred while editing the circuit(s).
{0}
{1}.
An error occurred when CTC tried to open
the circuit for editing.
EID-2007 The preferences could not be saved. CTC cannot save the preferences.
EID-2008 The circuit preferences could not be saved:
{0}
CTC cannot find the file needed to save the
circuit preferences.
EID-2009 CTC was unable to download the package:
{0}
Refer to the error message text.
EID-2010 An error occurred while deleting the destination. CTC could not delete the destination.
EID-2011 The circuit could not be destroyed. CTC could not destroy the circuit.
EID-2012 The reverse circuit could not be destroyed. CTC could not reverse the circuit destroy.
EID-2013 The circuit creation failed.
The circuit creation cannot proceed due to changes in the
network which affected the circuit(s) being created.
The dialog box will close. Please try again.
Refer to the error message text.
EID-2014 No circuit(s) were selected.
{0}
You must select a circuit to complete this
function.
EID-2015 The circuit {0} cannot be deleted because it has one or more
rolls.
You must delete the rolls in the circuit
before deleting the circuit itself.
EID-2016 The circuit deletion failed. CTC could not delete the tunnel as there are
circuits that use the tunnel.
EID-2017 An error occurred while mapping the circuit.
{0}
There was an error mapping the circuit.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description