4-5
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-2018 The circuit roll failed.
The circuit must be in the DISCOVERED state in order to
perform a roll.
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
EID-2019 The circuit roll failed.
Bridge and roll is not supported on DWDM circuits.
Refer to the error message text.
EID-2020 The circuit roll failed.
The two circuits must have the same direction.
Refer to the error message text.
EID-2021 The circuit roll failed.
The two circuits must have the same size.
Refer to the error message text.
EID-2022 The circuit roll failed.
A maximum of two circuits can be selected for a bridge and roll
operation.
Refer to the error message text.
EID-2023 CTC was unable to create a new user account. Refer to the error message text.
EID-2024 An error occurred during node selection. There was an error during node selection.
EID-2025 This feature cannot be used. Verify that each endpoint of this
circuit is running software that supports this feature.
Refer to the error or warning message text.
For example, this error is generated from
the node view Provisioning> WDM-ANS>
tabs to indicate that the selected ring type is
not supported by the endpoints of the
circuit. Another example is the
Provisioning> VLAN tabs in card view
(Ethernet card only), where it indicates that
the back-end spanning tree protocol (STP)
disabling is not supported.
EID-2026 The {0} request could not be applied.
{1}
Error occurred while attempting to switch a
path protection.
EID-2027 An error occurred while deleting the circuit drop. CTC could not delete the circuit drop.
EID-2028 An error occurred while removing the circuit node. CTC could not remove the circuit node.
EID-2029 The requested operation is not supported. The task you are trying to complete is not
supported by CTC.
EID-2030 An error occurred during provisioning. There was an error during provisioning.
EID-2031 An error occurred while adding the node. There was an error while adding a node.
EID-2032 The circuit could not be renamed.
{0}
CTC could not rename the circuit.
EID-2033 An error occurred during validation.
{0}
There was an internal error while validating
the user changes after the Apply button was
pressed. This error can occur in the Edit
Circuit dialog box or in the BLSR table in
the shelf view (rare condition).
EID-2034 Network circuits could not be added:
{0}
Refer to the error message text.
EID-2035 The source and destination nodes are not connected. Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
