Cisco ONS 15454 - Page 499

4-11
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-2147 This is a security violation.
You may only change your own account.
You cannot change an account other than
your own.
EID-2148 This is a security violation.
You cannot delete the account under which you are currently
logged in.
You cannot delete the account you are
currently logged in.
WID-2149 There is no exportable content in this view. Refer to the error message text.
WID-2150 The node {0} is not initialized.
Please wait and try again.
Wait till the specified node is initialized and
try again.
WID-2152 Spanning tree protection is being disabled for this circuit. Refer to the warning message text.
WID-2153 Adding this drop will make the circuit a PCA circuit. Refer to the warning message text.
WID-2154 Monitor circuits cannot be created on a port grouping circuit. Refer to the warning message text.
WID-2155 Switch counts might not be fully supported on some nodes.
{0}
The specified nodes do not support switch
counts completely.
WID-2156 The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities are in
service and error-free.
Refer to the warning message text.
WID-2157 The roll(s) cannot be completed.
{0}
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
EID-2158 The roll mode is invalid.
{0}
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one- way
circuit destination roll, the roll mode must
be manual.
EID-2159 The roll is not ready for completion.
{0}
The roll is not ready for completion.
EID-2160 The roll is not connected.
{0}
Refer to error message text.
EID-2161 The sibling roll is not complete.
{0}
One of the rolls is not completed for the
dual roll. If it is auto roll, it will be
completed when a valid signal is detected.
If it is a manual roll, you must complete the
roll from CTC if Bridge and Roll is
operated from CTC, or from TL1 if Bridge
and Roll is operated from TL1.
EID-2162 An error occurred during roll acknowledgement.
{0}
Refer to the error message text.
EID-2163 The roll cannot be canceled.
{0}
CTC cannot cancel the roll.
EID-2164 An error occurred during the roll.
{0}
CTC encountered a roll error.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description