4-12
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-2165 The MAC address of the node {0} has been changed. All
circuits originating from or dropping at this node will need to
be repaired.
Repair the circuits that originate from or
drop at the specified node, with the new
MAC address.
WID-2166 The node cannot be inserted into the domain because it is not
initialized.
Initialize the node and proceed.
WID-2167 You have insufficient security privileges to perform this action. You do not have the privilege to perform
this action.
WID-2168 The following warnings surfaced while loading {0}.
{1}
CTC encountered warnings while loading
the alarm profile import file.
WID-2169 One or more of the profiles selected do not exist on one or more
of the nodes selected.
The profile selected does not exist on the
node. Select another profile.
WID-2170 The profile list on node {0} is full. Please delete one or more
profiles if you wish to add the profile.
{1}
The number of profile that can exist on a
node has reached the limit. To add a profile,
delete any of the existing profiles.
WID-2171 You have been logged out. Click OK to exit CTC. Refer to the warning message text.
WID-2172 The CTC CORBA (IIOP) listener port setting of {0} will be
applied on the next CTC restart.
The Internet Inter-ORB Protocol (IIOP)
listener port setting for the CTC Common
Object Request Broker Architecture
(CORBA) will be applied on the next CTC
restart.
EID-2173 The port is unavailable.
The desired CTC CORBA ({0}) listener port, {1}, is already in
use or you do not have permission to listen on it. Please select
an alternate port.
Select an alternate port, as the current port
is either in use or you do not have enough
permission on it.
EID-2174 An invalid number was entered. Please check it and try again. You entered an invalid firewall port number.
Try again.
WID-2175 An extension byte mismatch occurred.
{0}
There is a mismatch with the extension
byte.
WID-2176 Not all spans have the same OSPF area ID.
This will cause problems with protection switching. To
determine the OSPF area for a given span, click on the span and
the OSPF area will be displayed in the pane to the left of the
network map.
Refer to the warning message text.
WID-2178 Only one edit pane can be opened at a time. The existing pane
will be displayed.
Refer to the warning message text.
WID-2179 No update is available because the circuit has been deleted. Refer to the warning message text.
EID-2180 The CTC initialization failed during step {0}. CTC initialization has failed in the specified
step.
EID-2181 This link cannot be included because it originates from the
destination.
You must not include this link as it
originates from destination of a circuit. It is
against the path selection algorithm.
EID-2182 The value of {0} is invalid. The value of the specified item is invalid.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
