4-17
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3026 The send DoNotUse attribute cannot be modified. You cannot modify the Send DoNotUse
field.
EID-3027 The SyncMsg attribute cannot be modified. You cannot modify the SyncMsg field.
EID-3028 The port type cannot be changed. You cannot change the port type.
EID-3029 Unable to switch to the byte because an overhead change is
present on this byte of the port.
Refer to the error message text.
EID-3031 An error occurred while hard-resetting the card. There was an error while resetting card
hardware.
EID-3032 An error occurred while resetting the card. There was an error while resetting the card.
EID-3033 The lamp test is not supported on this shelf. Refer to the error message text.
EID-3035 The cross-connect diagnostics cannot be performed Refer to the error message text.
EID-3036 The cross-connect diagnostics test is not supported on this
shelf.
The cross-connect diagnostics test is not
supported on this shelf.
EID-3039 An error occurred while changing the card type. There was an error while changing the card.
EID-3040 The card type is invalid. The selected card type is invalid.
EID-3041 An error occurred while applying changes. CTC is unable to create a protection group.
Check if the protect port supports circuits, a
timing reference, SONET SDCC,
orderwire, or a test access point.
EID-3042 The flow control low value must be less than the flow control
high value for all ports in the card.
Refer to the error message text.
EID-3046 The flow control watermark value must be between {0} and
{1}, inclusive.
The flow control watermark value must be
between the two specified values.
EID-3047 The file {0} could not be read.
Please verify the name and try again.
Refer to the error message text.
EID-3048 There is no Cisco IOS startup configuration file available to
download.
CTC could not find the configuration file
for IOS startup.
EID-3049 The download cannot be done at this time because an update in
progress.
Refer to the error message text.
EID-3050 An error occurred while trying to save the file to your local file
system.
Check whether the file already exists and
cannot be over written, or there is a space
constraint in the file system.
EID-3051 The configuration file has a maximum size of {0} bytes. The size of the configuration file should not
exceed the specified number of bytes.
EID-3052 An error occurred while saving the configuration file to the
TCC2/TCC2P.
Refer to the error message text.
EID-3053 The value of {0} must be between {1} and {2}. The value of the item must be between the
specified values.
EID-3054 The provisioned input/output ports cannot be removed or
another user is updating the card. Please try to remove these
ports later.
Another user may be updating the card. You
can try again later.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
