4-19
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3078 An optical link could not be created. Refer to the error message text.
EID-3079 Defaults cannot be applied to the node. {0} CTC cannot apply the defaults to the
specified node.
EID-3080 CTC cannot navigate to the target tab.
{0}
CTC cannot go to the specified target tab.
EID-3081 The port type cannot be changed. Refer to the error message text.
EID-3082 The {0} extension byte cannot be changed. You cannot modify the specified extension
byte.
EID-3084 An error occurred while retrieving laser parameters for {0}. There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
EID-3085 No OSC Terminations were selected Select an OSC termination and proceed.
EID-3086 One or more Osc terminations could not be created. Refer to the error message text.
EID-3087 The OSC termination could not be edited. Refer to the error message text.
EID-3088 No {0} card is present to switch. No card of the specified type is available to
switch.
EID-3089 The {0} state cannot be used or changed when the {1} has
failed or is missing.
You cannot use or change the specified state
when the card is failed or missing.
EID-3090 The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
You cannot perform operation.
EID-3091 The operation cannot be performed because the protect card is
active.
Refer to the error message text.
EID-3092 The requested action cannot be applied because the service
state is invalid.
Select another service state and proceed.
EID-3093 The operation cannot be performed because the duplex pair is
{0}locked.
Refer to the error message text.
EID-3094 The operation cannot be performed because no cross-connect
redundancy is available.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
EID-3095 The deletion failed because the circuit is in use Refer to the error message text.
WID-3096 An internal communication error was encountered while
retrieving laser parameters.
This can happen when equipment is not present or when
equipment is resetting.
Check the equipment state and try to refresh the values again.
Refer to the warning message text.
EID-3097 The ring termination is in use. The ring termination you are trying to
access is in use. Try after sometime.
EID-3098 No ring terminations were selected. Select one of the ring terminations.
EID-3099 The entered key does not match the existing authentication key. Check the authentication key and reenter.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
