4-20
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-3100 An error occurred during authentication. There was an error in authentication. Verify
that the key does not exceed the character
limit.
EID-3101 The DCC metric must be between 1 and 65535. The DCC metric should be in the range of 1
to 65535.
EID-3102 The DCC metric is invalid. There was an invalid DCC metric.
EID-3103 The IP address {0} is invalid}. The IP address is invalid.
EID-3104 The router priority must be between 0 and 255. The router priority should be in the range of
0 to 255.
EID-3105 The router priority is invalid. The router priority is invalid.
EID-3106 The hello interval must be between 1 and 65535. The hello interval should be in the range of
1 to 65535.
EID-3107 The hello interval is invalid. The hello interval is invalid.
EID-3109 The dead interval must be between 1 and 2147483647. The dead interval value must be between 1
and 2147483647.
EID-3110 The dead interval must be larger than the hello interval. Refer to the error message text.
EID-3111 The LAN transmit delay must be between 1 and 3600 seconds. The LAN transit delay should be in the
range of 1 to 3600 seconds.
EID-3112 The transmit delay is invalid. The transmit delay is invalid.
EID-3113 The retransmit interval must be between 1 and 3600 seconds. The retransmit interval should be in the
range of 1 to 3600 seconds.
EID-3114 The retransmit interval is invalid. The retransmit interval is invalid.
EID-3115 The LAN metric must be between 1 and 65535. The LAN metric should be in the range of 1
to 65535.
EID-3116 The LAN metric is invalid. The LAN metric is invalid.
EID-3117 If OSPF is active on the LAN, no DCC area IDs may be 0.0.0.0.
Please change all DCC area IDs to non-0.0.0.0 values before
enabling OSPF on the LAN.
Refer to the error message text.
EID-3118 If OSPF is active on the LAN, the LAN area ID cannot be the
same as the DCC area ID.
LAN must be part of a different OSPF area
other than the DCC network.
EID-3119 An error occurred during validation. CTC was unable to validate the values
entered by the user. This error message is
common to several different provisioning
tabs within CTC (examples include the
SNMP provisioning tab, the General>
Network provisioning tab, the Security >
Configuration provisioning tab, etc.).
EID-3120 No object of type {0} was selected for deletion. Choose an object of the specified type to
delete.
EID-3121 An error occurred while deleting {0}. There is an error deleting the item.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
