4-37
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-5057 The addition of the last node has not yet finished.
Please wait before trying to add a new node.
Refer to the error message text.
EID-5058 An OCHNC upgrade is applicable only to bidirectional circuits. Refer to the error message text.
EID-5059 The OCHNC upgrade failed.
One or more communication failures occurred during the
operation.
CTC encountered a complete failure while
upgrading optical channel network
connection.
EID-5060 The OCHNC upgrade partially failed.
One or more communication failures occurred during the
operation.
Create the OCHCC manually.
CTC encountered a partial failure while
upgrading an optical channel network
connection.
EID-5061 The overhead circuit source and destination must reside on the
same shelf.
Refer to the error message text.
EID-5062 A four-fiber {0} cannot be created using three cards. A four-fiber BLSR needs four cards.
WID-5063 The profile "{0}" includes a change to the OPEN-SLOT alarm
severity.
This change is disallowed for the ONS 15600. "{1}" will
continue to use the OPEN-SLOT severity of MN that is
included in the default configuration.
Other changes from the "{2}" profile were successfully applied
to {3}".
Refer to the warning message text.
EID-5064 {0}
{1}
This indicates the status of path protection
switching.
WID-5065 If you apply routing constraints to more than {0} nodes,
performance might be affected and the operation might require
more time than expected.
Select Yes if you intend to proceed in spite of this risk, or No if
you prefer to review your selection.
Refer to the warning message text.
WID-5066 The routing constraints will be lost.
Are you sure you want to reset your changes?
Refer to the warning message text.
WID-5067 The routing constraints will be lost.
Are you sure you want to leave this panel?
Refer to the warning message text.
EID-5068 The routing constraints could not be applied. Refer to the error message text.
EID-5069 A source node cannot be added to either of these lists. Select a node other than the source node to
add to the route.
EID-5070 A destination node cannot be added to either of these lists. Select a node other than the destination
node to add to the route.
EID-5071 This node already belongs to one of these lists. The node is already selected either in
include or exclude list in the OCH circuit.
EID-5072 An OCH-Trail tunnel link was found but without any associated
circuit.
Create an OCH-Trail circuit associated with
the link.
EID-5073 You are creating an unprotected link from a protected port.
Do you want to continue?
Refer to the error message.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
