4-42
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-6063 The selected router does not exist. Create a router.
EID-6064 The MAA address list is full. Refer to the error message text.
EID-6065 The selected area address is duplicated. Enter another area address.
EID-6066 The primary area address cannot be removed. Refer to the error message text.
EID-6067 The selected area address does not exist. Choose another area address.
EID-6068 The IP-over-CLNS NSEL cannot be modified while there are
IP-over-CLNS tunnel routes provisioned.
You cannot change the NSEL address if
tunnels are provisioned.
EID-6069 The node is currently in ES mode. Only Router 1 can be
provisioned.
An End System needs only one provisioned
router.
EID-6070 No router was selected. Select a router.
EID-6071 The TARP data cache cannot be flushed. You cannot flush the cache in the Tunnel
identifier Address Resolution Protocol
(TARP) state.
EID-6072 The TARP data cache entry cannot be added:
{0}
You cannot add the specified cache entry.
WID-6073 A TARP request has been initiated.
Try refreshing the TARP data cache later.
Refer to the warning message text.
EID-6074 End system mode only supports one subnet. Refer to the error message text.
EID-6075 An error occurred while trying to remove a MAT entry. The
entry does not exist.
CTC is removing the MAT entry.
EID-6076 An error occurred while trying to {0} a TARP manual
adjacency entry:
{1}
CTC cannot add the specified adjacency
entry for reasons unknown.
EID-6077 The area address must be between 1 and 13 bytes long,
inclusive.
The area address should not be more than 13
characters.
EID-6078 A TDC entry with this TID {0} does not exist in the table. The specified Tunnel Identifier does not
exist.
EID-6079 A TDC entry with this TID {0} could not be removed.
Please verify that TARP is enabled.
You must enable TARP to remove the TDC
entry.
WID-6080 Router {0} does not have an area address in common with
Router 1. Switching from IS L1/L2 to IS L1 in this case will
partition your network.
Refer to the warning message text.
EID-6081 The limit of 10 RADIUS server entries has been reached. CTC does not allow more than 10 RADIUS
servers.
EID-6082 {0} cannot be empty. The Shared Secrets field should not be
empty.
EID-6083 The entry you selected for editing has been altered by another
user. The changes cannot be committed.
Refer to the error message text.
EID-6084 The RADIUS server entry already exists. Specify another RADIUS server entry.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
