4-43
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-6085 Disabling shell access will prevent Cisco TAC from connecting
to the vxWorks shell to assist users.
Refer to the warning message text.
EID-6086 The card cannot be changed because card resources are in use. The card you are trying to remove is being
used. Cannot change the card.
EID-6087 The card cannot be changed because the card type is invalid or
incompatible.
Refer to the error message text.
EID-6088 This line cannot be put into loopback while it is in use as a
timing source.
Refer to the error message text.
EID-6089 The interface was not found. {0} CTC cannot find the specified interface.
EID-6090 The interface type is not valid for this operation. {0} Choose another interface.
EID-6091 The current state of the interface prohibits this operation. {0} The port is in an invalid state to set a
loopback.
EID-6092 This operation is prohibited for this interface. {0} CTC does not allow this operation for the
specified interface.
EID-6093 The maximum number of TARP data cache entries has been
exceeded.
You have exceeded the number of
characters permitted.
EID-6094 The maximum number of manual adjacency table entries has
been exceeded.
Refer to the error message text.
EID-6095 The AIS/Squelch mode is invalid. Refer to the error message text.
EID-6096 A default IP-over-CLNS tunnel route is only allowed on a node
without a default static route and a default router of 0.0.0.0.
Refer to the error message text.
EID-6097 The authorization key does not comply with Cisco IOS
password restrictions.
{0}
Specify another authorization key.
EID-6098 A default static route is not allowed when a default
IP-over-CLNS tunnel exists.
Refer to the error message text.
EID-6099 You cannot create a subnet on a disabled router. Create the subnet on an active router.
WID-6100 Disabling a router that has a provisioned subnet is not
recommended.
Refer to the warning message text.
EID-6101 The MAT entry already exists. Refer to the error message text.
WID-6102 The new card has less bandwidth than the current card. Circuits
of size VT15 and larger will be deleted.
Refer to the warning message text.
EID-6103 The TDC entry already exists. Specify another entry for TARP Data
Cache.
EID-6104 APC ABORTED. Automatic Power Control is aborted.
EID-6105 The 'Change Card' command is valid for MRC cards only when
Port 1 is the sole provisioned port.
Refer to the error message text.
EID-6106 To delete all RADIUS server entries, RADIUS authentication
must be disabled.
Disable Radius authentication and proceed.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
