4-48
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-6226 Invalid buffer size value The Buffer size value is invalid. Enter
again.
EID-6227 Invalid egress QOS value The egress QOS value is invalid. Enter
again.
EID-6228 Invalid QinQ working Mode The QinQ working mode is invalid. Enter
again.
EID-6229 Configured protection status Not Supported The protection status is not supported
EID-6230 The number of provisioned entries exceeds the limit Refer to the error message text.
EID-6231 This is not a valid VLAN ID. Entered VLAN ID is not present in the
database file.
EID-6232 The VLAN remapping ID is not allowed. Refer to the error message text.
EID-6233 The CVLAN is duplicated. You cannot have identical CVLAN IDs.
EID-6234 The VLAN ID is out of range. The VLAN ID entered is out of range.
EID-6235 This is not a valid VLAN name. The entered VLAN name exceeds the
number of characters (32) allowed.
EID-6236 The protected VLAN number exceeds the maximum allowed. The user enters more than 256 protected
VLAN in the VLAN database.
EID-6237 The port is not in OOS disabled admin state Refer to the error message text.
EID-6238 The VLAN ID is in use. The entered VLAN ID is in use by a node.
EID-6239 APC wrong node side. Refer to the error message text.
EID-6240 You cannot change the Admin State for an interlink port when
it is part of an ADM peer group. This operation is not
supported.
Refer to the error message text.
EID-6242 The protection slot is invalid. You must select a valid protection slot.
EID-6243 The {0} address of {1} is invalid. Refer to the error message text.
EID-6244 The mask of {0} is invalid. The mask of the specified value is not valid.
EID-6245 The cost must be between 1 and 32767. Refer to the error message text.
EID-6246 The {0} address cannot be {1}. Refer to the error message text.
EID-6247 The authentication type is invalid. Enter a valid authentication type.
EID-6248 The cost must between 1 and 15. Refer to the error message text.
EID-6249 The port has a cross-connect. Refer to the error message text.
EID-6250 The reversion time is invalid. The reversion time is invalid. Enter again.
EID-6251 Invalid Margin For Span Aging.
Value is not in the range 0 - 10.
Enter a value between 0 and 10.
EID-6252 The data cannot be retrieved because ANS parameters cannot
be calculated on the node in its current configuration.
Refer to the error message text.
EID-6253 Invalid Margin For Span Aging. Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
