Cisco ONS 15454 - Page 542

Index
IN-2
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
APC-OUT-OF-RANGE 2-39
APC-WRONG-GAIN 2-39
APSB 2-39
APSCDFLTK 2-39
APSC-IMP 2-40
APSCINCON 2-41
APSCM 2-42
APSCNMIS 2-43
APSIMP 2-44
APS-INV-PRIM 2-44
APSMM 2-44
APS-PRIM-FAC 2-45
APS-PRIM-SEC-MISM 2-46
ARP 1-132
AS-CMD 2-46
AS-MT 2-47
AS-MT-OOG 2-48
asynchronous mapping 2-196
AUD-ARCHIVE FAIL 3-5
AUD-LOG-LOSS 2-48
AUD-LOG-LOW 2-49
AUTOLSROFF 2-49
automatic protection switching
byte failure 2-39
channel failure on protect card 2-111
channel mismatch 2-42
invalid k bytes 2-40
mode mismatch failure 2-44
path protection alarms 2-52, 2-53, 2-54
path protection switch (condition) 2-53
ring switch failure 2-96
span switch failure 2-98
automatic reset 2-51
AUTONEG-RFI 2-50
AUTORESET 2-51
AUTOSW-AIS 2-51
AUTOSW-LOP (STSMON) 2-52
AUTOSW-LOP (VT-MON) 2-52
AUTOSW-PDI 2-53
AUTOSW-SDBER 2-53
AUTOSW-SFBER 2-54
AUTOSW-UNEQ (STSMON) 2-54
AUTOSW-UNEQ (VTMON) 2-55
AUTOWDMANS 3-5
AWG-DEG 2-55
AWG-FAIL 2-55
AWG-OVERTEMP 2-55
AWG-WARM-UP 2-55
B
B8ZS 2-148, 2-149
BAT-FAIL 2-56
BER
threshold range 2-217, 2-218
verify threshold level 2-275
BERT-ENBL 2-56
BERT-SYNC-FAIL 2-56
BIC logical object 2-20
bit error rate see BER
BITS
daisy-chained 1-139
errors 1-138
holdover timing 1-139
loss of frame 2-147
loss of signal 2-157
BITS logical object 2-20
BKUPMEMP 2-56
BLSR
change node ID number 2-261
change ring name 2-261
far-end protection line failure 2-111
improper configuration (alarms) 2-39
manual span condition 2-180
ring mismatch 2-207
ring switch failure 2-97
squelch alarm 2-228
verify node visibility 2-261