xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1015
DGS-3620-28PC:admin# config ptp boundary priority1 127
Command: config ptp boundary priority1 127
Success.
88-7 config ptp ports
Description
This command is used to configure the per port state of the PTP clock.
PTP port active state should meet the following three conditions:
• The global PTP state is enabled.
• The port PTP state is enabled.
• The port is not blocked, if the stp state is enabled.
Format
config ptp ports [<portlist> | all] state [enable | disable]
Parameters
ports - Specifies the list of port used for this configuration.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies that all the ports will be used for this configuration.
state - Specifies the port state of the PTP clock function.
enable - Specifies that the port state of the PTP clock function will be enabled.
disable - Specifies that the port state of the PTP clock function will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable PTP on ports 1:1-1:4:
DGS-3620-28PC:admin# config ptp ports 1:1-1:4 state enable
Command: config ptp ports 1:1-1:4 state enable
Success.
88-8 config ptp boundary ports
Description
This command is used to configure the attributes of the PTP boundary clock. The configuration
takes effect when the PTP device is a boundary type.
To Next Page
Loading...
