D-Link xStack DGS-3620 Series - Config Vlan

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1271
Parameters
<vidlist> - Enter a range of VLAN ID to be deleted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To remove a VLAN ID 2:
DGS-3620-28PC:admin#delete vlan vlanid 2
Command: delete vlan vlanid 2
Success.
DGS-3620-28PC:admin#
121-5 config vlan
Description
This command is used to add or delete ports to or from the port list of a previously configured
VLAN. Users can specify the additional ports as tagged, untagged, or forbidden.
Format
config vlan <vlan_name 32> {[add [tagged | untagged | forbidden] | delete] <portlist> |
advertisement [enable | disable]}(1)
Parameters
<vlan_name 32> - Enter the name of the VLAN to be configured. The maximum length is 32
characters.
add - Specifies the port attribute to add.
tagged - Specifies the additional ports as tagged.
untagged - Specifies the additional ports as untagged.
forbidden - Specifies the ports to be forbidden from becoming members of the VLAN
dynamically and not able to forward packets in this VLAN.
delete - Specifies the port status to delete.
<portlist> - Enter a range of ports to be added to or deleted from the VLAN.
advertisement - Specifies to send GVRP out for this VLAN or not. If not, the VLAN cannot be
joint dynamically.
enable - Specifies to enable GVRP.
disable - Specifies to disable GVRP.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.