xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
307
all - Display all port’s counters.
If no parameter is specified, display the global counters.
Restrictions
Only Administrator level users can issue this command.
Example
To show the STP counters for port 9:
DGS-3620-28PC:admin#debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive: Transmit:
Total STP Packets : 0 Total STP Packets : 0
Configuration BPDU : 0 Configuration BPDU : 0
TCN BPDU : 0 TCN BPDU : 0
RSTP TC-Flag : 0 RSTP TC-Flag : 0
RST BPDU : 0 RST BPDU : 0
Discard:
Total Discarded BPDU : 0
Global STP Disabled : 0
Port STP Disabled : 0
Invalid packet Format : 0
Invalid Protocol : 0
Configuration BPDU Length : 0
TCN BPDU Length : 0
RST BPDU Length : 0
Invalid Type : 0
Invalid Timers : 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
20-12 debug stp show flag
Description
This command used to display the STP debug level on specified ports.
Format
debug stp show flag {
ports <portlist>}
Parameters
ports - (Optional) Specifies the STP ports to display.
<portlist> - (Optional) Enter the list of port used for this configuration here.
If no parameter is specified, all ports on the switch will be displayed.
To Next Page
Loading...
