D-Link xStack DGS-3620 Series - Config Dscp Trust

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1051
91-15 show hol_prevention
Description
This command is used to display the head of line prevention state on the switch.
Format
show hol_prevention
Parameters
None.
Restrictions
None.
Example
To display HOL prevention state on the switch:
DGS-3620-28PC:admin#show hol_prevention
Command: show hol_prevention
Device HOL Prevention State: Enabled
DGS-3620-28PC:admin#
91-16 config dscp trust
Description
This command is used to enable or disable the DSCP trust state on specified ports.
Format
config dscp trust [<portlist>|all] state [enable | disable]
Parameters
<portlist> - Specifies a range of ports to be displayed.
all - Specifies that the command will apply to all ports on the switch.
state - Enables/disables DSCP trust. By default, DSCP trust is disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable DSCP trust on ports 1:1-1:8: