D-Link xStack DGS-3620 Series - Chapter 81 Password Recovery Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
942
Chapter 81 Password Recovery
Commands
enable password_recovery
disable password_recovery
show password_recovery
81-1 enable password_recovery
Description
This command is used to enable the password recovery mode.
Note: The configuration does not take effect until saved.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the password recovery mode:
DGS-3620-28PC:admin# enable password_recovery
Command: enable password_recovery
Success.
DGS-3620-28PC:admin#
81-2 disable password_recovery
Description
This command is used to disable the password recovery mode.
Note: The configuration does not take effect until saved.
Format
disable password_recovery