D-Link xStack DGS-3620 Series - Delete Ipif

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
577
DHCPDISCOVER and DHCPREQUEST messages.
dhcpv6_client_pd - Specifies the DHCPv6 client PD configuration.
enable - Specifies to enable the DHCPv6 client PD state of the interface.
prefix_name - Specifies an alias name for the prefix requested from the delegation router. If
disable the DHCPv6 client PD the name will be automatic clear.
<string 1-12> - Enter the prefix alias name. This name can be up to 12 characters long.
disable - Specifies to disable the DHCPv6 client PD state of the interface.
rapid_commit - (Optional) Specifies to allow the two-message exchange method for prefix
assignment.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the System IP interface:
DGS-3620-28PC:admin#config ipif System vlan v1
Command: config ipif System vlan v1
Success.
DGS-3620-28PC:admin#
47-3 delete ipif
Description
This command is used to delete an interface or an IPv6 address.
Format
delete ipif [<ipif_name 12> {ipv6address {prefix_name <string 1-12>} <ipv6networkaddr>} |
all]
Parameters
<ipif_name 12> - The name of the interface.
ipv6address - (Optional) The IPv6 network address to be deleted.
prefix_name - Specifies the IPv6 prefix name.
<string 1-12> - Enter the IPv6 prefix name. This name can be up to 12 characters long.
<ipv6networkaddr> - The IPv6 network address to be deleted.
all - All IP interfaces except the System IP interface will be deleted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete interface petrovic1:
DGS-3620-28PC:admin#delete ipif petrovic1