D-Link xStack DGS-3620 Series - Chapter 123 VLAN Trunking Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1290
Chapter 123 VLAN Trunking
Commands
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist> | all] state [enable | disable]
show vlan_trunk
123-1 enable vlan_trunk
Description
This command is used to enable VLAN trunking. When VLAN trunking function is enabled, the
VLAN trunk ports shall be able to forward all tagged frames with any VID.
Format
enable vlan_trunk
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable VLAN trunking:
DGS-3620-28PC:admin#enable vlan_trunk
Command: enable vlan_trunk
Success
DGS-3620-28PC:admin#
123-2 disable vlan_trunk
Description
This command is used to disable VLAN trunking.
Format
disable vlan_trunk