D-Link xStack DGS-3620 Series - Show Radius

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
49
<udp_port_number 1-65535> - The authentication port value must be between 1 and 65535.
default - Specifies to use the default value.
acct_port - Specifies the UDP port number which is used to transmit RADIUS accounting
statistics between the switch and the RADIUS server. The default is 1813.
<udp_port_number 1-65535> - The accounting statistics value must be between 1 and
65535.
default - Specifies to use the default value.
timeout - Specifies the time in seconds for waiting for a server reply. The default value is 5
seconds.
<int 1-255> - Enter the time in seconds for waiting for a server reply. The timeout value must
be between 1 and 255. The default value is 5 seconds.
default - Specifies to use the default value.
retransmit - Specifies the count for re-transmission. The default value is 2.
<int 1-20> - The re-transmit value must be between 1 and 20.
default - Specifies to use the default value.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a RADIUS server:
DGS-3620-28PC:admin#config radius 1 ipaddress 10.48.74.121 key dlink
Command: config radius 1 ipaddress 10.48.74.121 key dlink
Success.
DGS-3620-28PC:admin#
3-24 show radius
Description
This command is used to display RADIUS server configurations.
Format
show radius
Parameters
None.
Restrictions
None.
Example
To display RADIUS server configurations:
DGS-3620-28PC:admin#show radius