D-Link xStack DGS-3620 Series - Clear Bgp

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
199
Example
To create a confederation, AS number is 20:
DGS-3620-28PC:admin# config bgp confederation identifier 20
Command: config bgp confederation identifier 20
Success.
DGS-3620-28PC:admin#
12-33 config bgp confederation peers
Description
The command is used to configure multiple adjacent Autonomous Systems in a confederation. The
Autonomous Systems specified in this command are visible internally to the confederation. Each
Autonomous System is fully meshed within itself or configures route reflector.
Format
config bgp confederation peers [add | delete] <aspath_list>
Parameters
peers - Specifies that a peer will be added or deleted.
add - Specifies that a peer will be added.
delete - Specifies that a peer will be deleted.
<aspath_list> - Enter the AS number for BGP peers that will belong to the confederation
here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To add two confederation peers, AS number are 50000 and 50001:
DGS-3620-28PC:admin# config bgp confederation peers add 50000,50001
Command: config bgp confederation peers add 50000,50001
Success.
DGS-3620-28PC:admin#
12-34 clear bgp
Description
This command is used to initiate a hard reset or a soft reset for a connection. If a soft reset is
applied to the inbound session, the session will not be rebuilded but the local inbound routing table