D-Link xStack DGS-3620 Series - Chapter 35 Energy Efficient Ethernet (EEE) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
489
Chapter 35 Energy Efficient
Ethernet (EEE) Commands
config eee ports [<portlist> | all] state [enable | disable]
show eee ports {<portlist>}
Note: This feature is only available on hardware version A1 and later.
35-1 config eee ports
Description
This command is used to enable or disable the EEE function on the specified port(s) on the Switch.
Format
config eee ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
state - Specifies the EEE state. The default is disabled.
enable - Enable the EEE function for the specified port(s).
disable - Disable the EEE function for the specified port(s).
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the EEE state on ports 1:2-1:5:
DGS-3620-28PC:admin#config eee ports 1:2-1:5 state enable
Command: config eee ports 1:2-1:5 state enable
Success.
DGS-3620-28PC:admin#
35-2 show eee ports
Description
This command is used to display the EEE function state on the specified port(s).