D-Link xStack DGS-3620 Series - Show Snmp Host; Show Snmp V6 Host

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1135
DGS-3620-28PC:admin#
102-18 show snmp host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp host {<ipaddr>}
Parameters
<ipaddr> - (Optional) Specifies the IP address of the recipient for which the traps are targeted.
Note: If no parameter is specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To display the receipient for which the traps are targeted:
DGS-3620-28PC:admin#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name UDP Port
--------------- --------------- --------------------------------- --------
10.90.90.6 V2c community3 162
Total Entries: 1
DGS-3620-28PC:admin#
102-19 show snmp v6host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp v6host {<ipv6addr>}