D-Link xStack DGS-3620 Series - Chapter 12 Border Gateway Protocol (BGP) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
165
Chapter 12 Border Gateway
Protocol (BGP) Commands
enable bgp
disable bgp
create bgp <as_number 1-4294967295>
delete bgp <as_number 1-4294967295>
config bgp router_id <ipaddr>
config bgp synchronization [enable | disable]
config bgp enforce_first_as [enable | disable]
create bgp aggregate_address [<network_address> | ipv6 <ipv6_networkaddr>] {summary_only
| as_set}
delete bgp aggregate_address [[<network_address> | all] | ipv6 [<ipv6_networkaddr> | all]]
show bgp aggregate_address {[<network_address> | ipv6 {<ipv6_networkaddr>}]}
create bgp network [<network_address> | ipv6 <ipv6_networkaddr>] {route_map <map_name
16>}
config bgp network [<network_address> | ipv6 <ipv6_networkaddr>] [route_map <map_name
16> | clear_routemap]
delete bgp network [[<network_address> | all] | ipv6 [<ipv6_networkaddr> | all]]
show bgp network {[<network_address> | ipv6 {<ipv6_networkaddr>}]}
config bgp timer holdtime <sec 0-65535> keepalive <sec 0-65535>
config bgp {always_compare_med [disable | enable] | deterministic_med [disable | enable] |
default_local_preference <uint 0-4294967295> | bestpath {as_path_ignore [disable | enable] |
compare_routerid [disable | enable] | med_confed [disable | enable] | med_missing_as_worst
[disable | enable] | compare_confed_aspath [disable | enable]}(1)}(1)
config bgp dampening {[ipv4 | ipv6] unicast} [route_map <map_name 16> | clear_routemap |
{state [enable | disable] | half_life <value 1-45> | reuse <value 1-20000> | suppress <value 1-
20000> | max_suppress_time <value 1-255> | un_reachability_half_life <value 1-45>}]
show bgp dampening {[ipv4 | ipv6] unicast}
config bgp peer_group <peer_group_name 16> [remote_as <as_number 0-4294967295> | [add |
delete] [<ipaddr> | <ipv6addr>]]
create bgp neighbor [[<ipaddr> | <ipv6addr>] [remote_as <as_number 1-4294967295> |
peer_group <peer_group_name 16>] | peer_group <peer_group_name 16>]
delete bgp neighbor [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16> | all]
config bgp neighbor [[[<ipaddr> | peer_group <peer_group_name 16>] [description <desc 80> |
clear_description | password <password 25> | clear_password]] | <ipv6addr> [description
<desc 80> | clear_description]]
config bgp neighbor session [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]
[{[ipv4 | ipv6] unicast} activity | state] [enable | disable]
config bgp neighbor general [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]
[{ebgp_multihop <value 1-255> | weight [<value 0-65535> | default] | update_source [add |
delete] ipif <ipif_name 12> | send_community [standard | none] | next_hop_self [enable |
disable] | soft_reconfiguration_inbound [enable | disable] | remove_private_as [enable |
disable] | allowas_in [enable {<value 1-10>} | disable] | default_originate [enable {route_map
<map_name 16>} | disable]} | [ipv4 | ipv6] unicast {send_community [standard | none] |
next_hop_self [enable | disable] | soft_reconfiguration_inbound [enable | disable] |
remove_private_as [enable | disable] | allowas_in [enable {<value 1-10>} | disable] |
default_originate [enable {route_map <map_name 16>} | disable]}]
config bgp neighbor timer [<ipaddr> | <ipv6addr> | peer_group <peer_group_name 16>]
{advertisement_interval [<sec 0-600> | default] | [keepalive <sec 0-65535> holdtime <sec 0-
65535> | default_keepalive_holdtime] | as_origination_interval [<sec 1-600> | default] |
connect [<sec 1-65535> | default]}
config bgp neighbor route_reflector_client [<ipaddr> | <ipv6addr> | peer_group