D-Link xStack DGS-3620 Series - Chapter 98 SD Card Management Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1091
Chapter 98 SD Card
Management commands
create backup [config | log] time_range <range_name 32> filename <pathname> {state [enable |
disable]}
config backup [config | log] time_range <range_name 32> filename < pathname > state [enable |
disable]
delete backup [config | log] [all | time_range <range_name 32> {filename < pathname >} ]
show backup {config | log}
create execute_config time_range <range_name 32> config < pathname > {state [enable |
disable] | [increment | reset]}
config execute_config time_range <range_name 32> config <pathname> {state [enable |
disable] | [increment | reset}
delete execute_config [all | time_range <range_name 32> { config <pathname>}]
show execute_config
execute config <pathname> {increment}
98-1 create backup
Description
This command is used to create a schedule to backup the configuration or log to file system.
Format
create backup [config | log] time_range <range_name 32> filename <pathname> {state
[enable | disable]}
Parameters
config - Backup the configuration on schedule.
log - Backup the log on schedule.
time_range - The time range for the scheduled backup of the configuration or log.
<range_name 32> - Enter the name of this time range entry. The maximum length is 32
characters.
Filename - The backup filename of the configuration or log.
<pathname> - Enter the path name of backup filename of the configuration or log.
State - Enable or disable the scheduled backup when schedule is created. If “state” is not
specified, the schedule will be disabled.
enable - Configure the scheduled backup state to enable.
disable - Configure the scheduled backup state to disable.
Restrictions
Only Administrators, Operators can issue this command.
Example
To create a backup schedule on time range” range_1”: