D-Link xStack DGS-3620 Series - Show Ipv6 Nd

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
637
Parameters
<ipif_name 12> - Enter the name of the interface. The maximum length is 12 characters.
<ipv6networkaddr> - Enter the IPv6 network address.
preferred_life_time - Specifies the number in seconds that an address, based on the specified
prefix using the stateless address configuration, remains in preferred state.
<sec 0-4294967295> - Enter the time between 0 and 4294967295 seconds. For an infinite
valid lifetime the value can be set to 4294967295.
valid_life_time - Specifies the number of seconds that an address, based on the specified prefix,
using the stateless address configuration, remains valid.
<sec 0-4294967295> - Enter the time between 0 and 4294967295 seconds. For an infinite
valid lifetime the value can be set to 4294967295.
on_link_flag - Specifies to enable or disable the function.
enable - Setting this field to enable will denote, within the IPv6 packet, that the IPv6 prefix
configured here is assigned to this link-local network. Once traffic has been successfully
sent to these nodes with this specific IPv6 prefix, the nodes will be considered reachable
on the link-local network.
disable - When set to disable, the addresses implied by the specified prefix are not available
on the link where the RA message is received.
autonomous_flag - Specifies to enable or disable the function.
enable - Setting this field to enable will denote that this prefix may be used to autoconfigure
IPv6 addresses on the link-local network.
disable - When set to disable, the specified prefix will not be used to create an autonomous
address configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the value of the preferred_life_time of prefix option to be 1000 seconds for the prefix
3ffe:501:ffff:100::/64, which is the prefix of the ip1 interface:
DGS-3620-28PC:admin#config ipv6 nd ra prefix_option ipif ip1
3ffe:501:ffff:100::/64 preferred_life_time 1000
Command: config ipv6 nd ra prefix_option ipif ip1 3ffe:501:ffff:100::/64
preferred_life_time 1000
Success.
DGS-3620-28PC:admin#
52-9 show ipv6 nd
Description
This command is used to display IPv6 Neighbor Discover related configuration.
Format
show ipv6 nd {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the interface name.