D-Link xStack DGS-3620 Series - Show Utilization Flash

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
855
Parameters
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
Restrictions
None.
Example
To display DRAM utilization:
DGS-3620-28PC:admin# show utilization dram
Command: show utilization dram
DRAM utilization :
Total DRAM : 262144 KB
Used DRAM : 119586 KB
Utilization : 45%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
75-6 show utilization flash
Description
This command is used to display real-time Flash utilization statistics.
Format
show utilization flash {unit <unit_id>}
Parameters
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
Restrictions
None.
Example
To display Flash utilization:
DGS-3620-28PC:admin#show utilization flash
Command: show utilization flash
Unit 1 Flash Memory Utilization :
Total Flash : 126253 KB
Used Flash : 8271 KB