D-Link xStack DGS-3620 Series - Chapter 30 Domain Name System (DNS) Relay Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
462
Chapter 30 Domain Name
System (DNS) Relay
Commands
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static <domain_name 32>
<ipaddr>]
enable dnsr {[cache | static]}
disable dnsr {[cache | static]}
show dnsr {static}
30-1 config dnsr
Description
This command is used to add or delete a static entry into the Switch’s DNS resolution table, or set
up the relay server.
Format
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
Parameters
primary - Specifies to indicate that the IP address below is the address of the primary DNS
server.
secondary - Specifies to indicate that the IP address below is the address of the secondary DNS
server.
nameserver - Specifies the IP address of the DNS nameserver.
<ipaddr> - Enter the IP address of the DNS nameserver.
add - Specifies to add the DNS relay function.
delete - Specifies to delete the DNS relay function.
static - Specifies the domain name of the entry.
<domain_name32> - Enter the domain name.
<ipaddr> - Enter the IP address of the entry.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set IP address 10.24.22.5 as the primary DNS server:
DGS-3620-28PC:admin# config dnsr primary nameserver 10.24.22.5
Command: config dnsr primary nameserver 10.24.22.5
Success.