D-Link xStack DGS-3620 Series - Show Ipif

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
579
all - All of the IP interfaces.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable the state for an interface:
DGS-3620-28PC:admin#disable ipif petrovic1
Command: disable ipif petrovic1
Success.
DGS-3620-28PC:admin#
47-6 show ipif
Description
This command is used to display IP interface settings.
Format
show ipif {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) The name of the interface.
Restrictions
None.
Example
To display IP interface settings:
DGS-3620-28PC:admin# show ipif
Command: show ipif
IP Interface : System
VLAN Name : default
Interface Admin State : Enabled
IPv4 Address : 10.90.100.100/16 (Manual) Primary
Proxy ARP : Disabled (Local : Disabled)
IP Directed Broadcast : Disabled
IPv4 State : Enabled
IPv6 SLAAC state : Disabled (Default Router: Disabled)
DHCPv6 Client State : Disabled (Rapid commit : Disabled)
DHCPv6 Client PD State : Disabled (Rapid commit : Disabled)