D-Link xStack DGS-3620 Series - Chapter 10 Auto Configuration Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
158
Chapter 10 Auto Configuration
Commands
show autoconfig
enable autoconfig
disable autoconfig
10-1 show autoconfig
Description
This command is used to display the status of automatically getting configuration from a TFTP
server.
Format
show autoconfig
Parameters
None.
Restrictions
None.
Example
To display the DHCP auto configuration status:
DGS-3620-28PC:admin#show autoconfig
Command: show autoconfig
Autoconfig State: Disabled
DGS-3620-28PC:admin#
10-2 enable autoconfig
Description
This command is used to enable automatically to get configuration from a TFTP server according
to the options in the DHCP reply packet. To employ this method, the DHCP server must be set up
to deliver the TFTP server IP address and configuration file name information first.
Format
enable autoconfig