xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
945
Chapter 82
Protocol
Independent Multicast (PIM)
Commands
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> | state
[enable | disable] | mode [dm | sm | sm-dm] | dr_priority <uint 0-4294967294> | passive
[enable | disable]}(1) | register_probe_time <value 1-127> | register_suppression_time <value
show pim neighbor {ipif <ipif_name 12> | ipaddress <network_address>}
show pim {ipif <ipif_name 12>}
config pim cbsr [ipif <ipif_name 12> {priority [-1 | <value 0-255>]} | hash_masklen <value 0-32> |
bootstrap_period <value 1-255>]
show pim cbsr {ipif <ipif_name 12>}
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]} (1)
create pim crp group <network_address> rp <ipif_name 12>
delete pim crp group <network_address>
config pim last_hop_spt_switchover [never | immediately]
create pim static_rp group <network_address> rp <ipaddr>
delete pim static_rp group <network_address>
show pim rpset {group <group>}
create pim register_checksum_include_data rp_address <ipaddr>
delete pim register_checksum_include_data rp_address <ipaddr>
show pim register_checksum_include_data_rp_list
config pim-ssm {state [enable | disable] | group_range [default | <network_address>]} (1)
show pim passive {ipif <ipif_name 12>}
82-1 config pim
Description
This command is used to configure the PIM settings.
Format
config pim [[ipif <ipif_name 12> | all] {hello <sec 1-18724> | jp_interval <sec 1-18724> | state
[enable | disable] | mode [dm | sm | sm-dm] | dr_priority <uint 0-4294967294> | passive
[enable | disable]}(1) | register_probe_time <value 1-127> | register_suppression_time
<value 3-255>]
Parameters
ipif - Specifies the IP interface name.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
To Next Page
Loading...
Need help?
General