D-Link xStack DGS-3620 Series - Chapter 75 Network Monitoring Commands; Show Packet Ports

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
848
Chapter 75 Network Monitoring
Commands
show packet ports <portlist> | groups < grouplist >]
show error ports <portlist> | groups < grouplist >]
show utilization [ ports {<portlist>} | groups {< grouplist >}]
show utilization cpu
show utilization dram {unit <unit_id>}
show utilization flash {unit <unit_id>}
clear counters {ports <portlist>} | groups < grouplist >}
clear log
show log {[index <value_list> | severity {module <module_list>} {emergency | alert | critical | error |
warning | notice | informational | debug | <level_list 0-7>} | module <module_list>]}
show log_save_timing
show log_software_module
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
enable syslog
disable syslog
show syslog
config syslog host [<index 1-4> | all] {severity [emergency | alert | critical | error | warning | notice
| informational | debug| <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 |
local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] | state
[enable | disable]}(1)
create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert |
critical | error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | state [enable |
disable]}
delete syslog host [<index 1-4> | all]
show syslog host {<index 1-4>}
config syslog source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
show syslog source_ipif
show attack_log {unit <unit_id 1-12>} {index <value_list>}
clear attack_log {[unit <unit_id 1-12> | all]}
show cpu port {[l2 | l3 {[unicast | multicast]} |type [lacp | stp | gvrp | erps | cfm | 802.1x | lldp | oam
| stacking | ctp | ospfv2 | ospfv3 | rip | ripng | bgp | vrrp | igmp | mld | pim-ipv4 | pim-ipv6 |
dvmrp | reserved_ipv4_ipmc | reserved_ipv6_ipmc | unknown_ipv4_ipmc |
unknown_ipv6_ipmc | arp | icmp | ndp | icmpv6 | sntp | dns | tftp | rcp | telnet | dhcp | dhcpv6 |
udp-helper]]}
clear cpu port
75-1 show packet ports
Description
This command is used to display statistics about the packets sent and received by the switch for a
range of ports or LAG groups.
Format
show packet [ ports <portlist> | groups < grouplist >]