D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
304
Example
To set the switch to not need a reboot when a fatal error occurs:
DGS-3620-28PC:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-3620-28PC:admin#
20-7 debug config state
Description
Use the command to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Enable the debug state.
disable - Disable the debug state.
Restrictions
Only Administrator level users can issue this command.
Example
To set the debug state to disabled:
DGS-3620-28PC:admin# debug config state disable
Command: debug config state disable
Success.
DGS-3620-28PC:admin#
20-8 debug show error_reboot state
Description
Use the command to show the error reboot status.
Format
debug show error_reboot state

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English