D-Link xStack DGS-3620 Series - Chapter 31 Domain Name System (DNS) Resolver Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
467
Chapter 31 Domain Name
System (DNS) Resolver
Commands
config name_server add [<ipaddr> | <ipv6addr>] {primary}
config name_server delete [<ipaddr> | <ipv6addr>] {primary}
config name_server timeout <second 1-60>
show name_server
create host_name <name 255> [<ipaddr> | <ipv6addr>]
delete host_name [<name 255> | all]
show host_name {static | dynamic}
enable dns_resolver
disable dns_resolver
31-1 config name_server add
Description
This command is used to add a DNS resolver name server to the Switch.
Format
config name_server add [<ipaddr> | <ipv6addr>] {primary}
Parameters
<ipaddr> - Enter the DNS Resolver name server IPv4 address used here.
<ipv6addr> - Enter the DNS Resolver name server IPv6 address used here.
primary – (Optional) Specifies that the name server is a primary name server.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add DNS Resolver primary name server 10.10.10.10:
DGS-3620-28PC:admin# config name_server add 10.10.10.10 primary
Command: config name_server add 10.10.10.10 primary
Success.
DGS-3620-28PC:admin#