D-Link xStack DGS-3620 Series - Chapter 112 Switch Port Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1205
Chapter 112 Switch Port
Commands
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto {capability_advertised
{10_half | 10_full | 100_half | 100_full | 1000_full}} | 10_half | 10_full | 100_half | 100_full |
1000_full {[master | slave]} | 10g_full] | auto_negotiation [restart_an | remote_fault_advertised
[disable | offline | link_fault | auto_negotiation_error]] | flow_control [enable | disable] | learning
[enable | disable] | state [enable | disable] | mdix [auto | normal | cross] | [description <desc 1-32>
| clear_description] | auto_speed_downgrade [enable | disable]}
show ports {<portlist>} {[description | err_disabled | auto_negotiation | details | media_type]}
112-1 config ports
Description
This command is used to change switch port settings.
Format
config ports [<portlist> | all] {medium_type [fiber | copper]} {speed [auto
{capability_advertised {10_half | 10_full | 100_half | 100_full | 1000_full}} | 10_half | 10_full |
100_half | 100_full | 1000_full {[master | slave]} | 10g_full] | auto_negotiation [restart_an |
remote_fault_advertised [disable | offline | link_fault | auto_negotiation_error]] |
flow_control [enable | disable] | learning [enable | disable] | state [enable | disable] | mdix
[auto | normal | cross] | [description <desc 1-32> | clear_description] |
auto_speed_downgrade [enable | disable]}
Parameters
<portlist> - Enter a range of ports to be configured.
all – Specifies to set all ports in the system.
medium_type - (Optional) Specifies the medium type when configuring ports that are combo
ports.
fiber - Specifies the fiber port.
copper - Specifies the copper port.
speed – Specifies to set port speed for the specified ports.
auto - Specifies to set the port speed to auto-negotiation.
capability_advertised - Specifies that the capability will be advertised.
10_half - Specifies to set the port speed to 10Mbps half-duplex.
10_full - Specifies to set the port speed to 10Mbps full-duplex.
100_half - Specifies to set the port speed to 100Mbps half-duplex.
100_full - Specifies to set the port speed to 100Mbps full-duplex.
1000_full - Specifies to set the port speed to 1Gbps full-duplexl. When setting the copper
port’s speed to 1Gbps full-duplex, users should specify the master and slave mode in
the pair for 1000BASE-T. For fiber connections the master or slave setting need not be
configured.
10g_full - Specifies to set the port speed to 10Gbps full-duplex.
master - (Optional) Specifies to set to master.
slave - (Optional) Specifies to set to slave.
auto_negotiation - Specifies that the auto-negotiation option will be configured.