D-Link xStack DGS-3620 Series - Show Rspan

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
1087
DGS-3620-28PC:admin#config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Command: config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Success.
DGS-3620-28PC:admin#
To configure an RSPAN source entry for per flow RSPAN, without any source ports:
DGS-3620-28PC:admin#config rspan vlan vlan_id 2 source
Command: config rspan vlan vlan_id 2 source
Success.
DGS-3620-28PC:admin#
To configure RSPAN redirect for “vlan2” to ports 18 and 19:
DGS-3620-28PC:admin#config rspan vlan vlan_name vlan2 redirect add ports 18-19
Command: config rspan vlan vlan_name vlan2 redirect add ports 18-19
Success.
DGS-3620-28PC:admin#
96-6 show rspan
Description
This command is used to display RSPAN configuration.
Format
show rspan {[vlan_name <vlan_name> | vlan_id <vlanid 1-4094>]}
Parameters
vlan_name - Specifies the RSPAN VLAN by VLAN name.
<vlan_name> - Enter the VLAN name.
vlan_id - Specifies the RSPAN VLAN by VLAN ID.
<vlanid 1-4094> - Enter the VLAN ID between 1 and 4094.
Restrictions
None.
Example
To display specific RSPAN settings:
DGS-3620-28PC:admin# show rspan vlan_id 63
Command: show rspan vlan_id 63
RSPAN : Enabled