D-Link xStack DGS-3620 Series - Chapter 11 Bidirectional Forwarding Detection (BFD) Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
160
Chapter 11 Bidirectional
Forwarding Detection (BFD)
Commands
enable bfd
disable bfd
config bfd [ipif <ipif_name 12> | all] {min_tx_interval <millisecond 50-1000> | min_rx_interval
<millisecond 50-1000> | multiplier <value 3-99> | slow_time <millisecond 1000-3000>}
show bfd {ipif <ipif_name 12>}
show bfd neighbor {ipif <ipif_name 12> | ipaddress <ipaddr> | protocol [ospf | vrrp] | details}
11-1 enable bfd
Description
This command is used to enable the BFD global state on the Switch.
Format
enable bfd
Parameters
None
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example show how to enable the BFD global state.
DGS-3620-28PC:admin# enable bfd
Command: enable bfd
Success.
DGS-3620-28PC:admin#
11-2 disable bfd
Description
This command is used to disable the BFD global state on the Switch.