D-Link xStack DGS-3620 Series - Chapter 49 IP Route Filter Commands

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
589
Chapter 49 IP Route Filter
Commands
create ip prefix_list <list_name 16>
config ip prefix_list <list_name 16> [[add | delete] {sequence <value 1-65535>}
<network_address> {ge <value 1-32>} {le <value 1-32>} [deny | permit] | [description <desc
80> | clear_description]]
delete ip prefix_list [list_name <list_name 16> | all]
show ip prefix_list {<list_name 16>}
create ip standard access_list <list_name 16>
config ip standard access_list <list_name 16> [add | delete] <network_address> [deny | permit]
delete ip standard access_list [list_name <list_name 16> | all]
show ip standard access_list {<list_name 16>}
clear ip prefix_list counter [<list_name 16> {<network_address>} | all]
create route_map <map_name 16>
config route_map <map_name 16> [[add | delete] sequence <value 1-65535> {[deny | permit]} |
sequence <value 1-65535> [match [add | delete] [as_path <list_name 16> | community_list
<list_name 16> {exact} | ip [next_hop | address] {prefix_list} <list_name 16> | metric <uint 0-
4294967294> | ipv6 [next_hop | address] {prefix_list} <list_name 16> | route_type [internal |
external | type_1 | type_2] | interface <ipif_name 12> | route_source <list_name 16>] | set
[add | delete] [next_hop [<ipaddr> | peer_address] | metric <uint 0-4294967294> |
local_preference <uint 0-4294967295> | weight <value 0-65535> | as_path <aspath_list> |
community {community_set <community_set 80> | internet | no_export | no_advertise |
local_as} {additive} | origin [egp | igp | incomplete] | dampening <min 1-45> <value 1-20000>
<value 1-20000> <min 1-255> <min 1-45> | ipv6 next_hop <ipv6addr> | metric_type [type_1 |
type_2]]]]
delete route_map [map_name <map_name 16> {all_seqence} | all]
show route_map {<map_name 16>}
create ipv6 prefix_list <list_name 16>
create ipv6 standard access_list <list_name 16>
config ipv6 prefix_list <list_name 16> [[add | delete] {sequence <value 1-65535>}
<ipv6_networkaddr> {ge <value 1-128>} {le <value 1-128>} [deny | permit] | [description
<desc 80> | clear_description]]
config ipv6 standard access_list <list_name 16> [add | delete] <ipv6_networkaddr> [deny |
permit]
show ipv6 prefix_list {<list_name 16>}
show ipv6 standard access_list {<list_name 16>}
clear ipv6 prefix_list counter [<list_name 16> {<ipv6_networkaddr>} | all]
delete ipv6 prefix_list [list_name <list_name 16> | all]
delete ipv6 standard access_list [list_name <list_name 16> | all]
49-1 create ip prefix_list
Description
This command is used to create an IP prefix list that can be further applied to routes as a filter list.
Format
create ip prefix_list <list_name 16>