D-Link xStack DGS-3620 Series - Config Arpentry

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
148
Format
delete arpentry [<ipaddr> | all]
Parameters
<ipaddr> - The IP address of the end node or station.
all - Delete all ARP entries
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete an entry of IP address 10.48.74.121 from the ARP table:
DGS-3620-28PC:admin#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DGS-3620-28PC:admin#
7-3 config arpentry
Description
This command is used to configure the IP address and MAC address of a static entry in the ARP
table.
Format
config arpentry <ipaddr> <macaddr>
Parameters
<ipaddr> - The IP address of the end node or station.
<macaddr> - The MAC address corresponding to the IP address above.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure a static ARP entry for the IP address 10.48.74.121 and MAC address
00:50:BA:00:07:36:
DGS-3620-28PC:admin#config arpentry 10.48.74.121 00-50-BA-00-07-36
Command: config arpentry 10.48.74.121 00-50-BA-00-07-36