D-Link xStack DGS-3620 Series - Debug Stp Clear Counter

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
305
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To show the error reboot status:
DGS-3620-28PC:admin#debug show error_reboot state
Command: debug show error_reboot state
Error Reboot: Enabled
DGS-3620-28PC:admin#
20-9 debug stp clear counter
Description
This command used to clear the STP counters.
Format
debug stp clear counter {ports [<portlist> | all]}
Parameters
ports - Specifies the port range.
<portlist> - Enter the list of port used for this configuration here.
all - Clears all port counters.
Restrictions
Only Administrator level users can issue this command.
Example
To clear all STP counters on the switch:
DGS-3620-28PC:admin# debug stp clear counter ports all
Command : debug stp clear counter ports all
Success.
DGS-3620-28PC:admin#