D-Link xStack DGS-3620 Series - Enable Ipif; Disable Ipif

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
578
Command: delete ipif petrovic1
Success.
DGS-3620-28PC:admin#
47-4 enable ipif
Description
This command is used to enable the state for an IPIF. When the state is enabled, the IPv4
processing will be started when an IPv4 address is configured on the IPIF. The IPv6 processing
will be started when an IPv6 address is explicitly configured on the IPIF.
Format
enable ipif [<ipif_name 12> | all]
Parameters
<ipif_name 12> - The name of the interface.
all - All of the IP interfaces.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the state for interface petrovic1:
DGS-3620-28PC:admin#enable ipif petrovic1
Command: enable ipif petrovic1
Success.
DGS-3620-28PC:admin#
47-5 disable ipif
Description
This command is used to disable the state of an interface.
Format
disable ipif [<ipif_name 12> | all]
Parameters
<ipif_name 12> - The name of the interface.