D-Link xStack DGS-3620 Series - Show Bfd

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
162
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example show how to configure the desired minimum TX interval value to 100 milliseconds
and detection time multiplier to 5 on the interface System.
DGS-3620-28PC:admin# config bfd ipif System min_tx_interval 100 multiplier 5
Command: config bfd ipif System min_tx_interval 100 multiplier 5
Success.
DGS-3620-28PC:admin#
11-4 show bfd
Description
This command is used to display the BFD information on the Switch.
Format
show bfd {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specifies the IP interface to display.
<ipif_name 12> - Enter the IP interface's name here. This name can be up to 12 characters
long.
Restrictions
None.
Example
This example show how to display the BFD information.